Rpm Steering Block Blue T og E-Maxx Revo 3.3 E-Revo old

Rpm Steering Block Blue T og E-Maxx Revo 3.3 E-Revo old

Quick Notes:

• Replaces stock Traxxas #5334
• Includes massive oversized bearings!
• Fits all Revo, e-Revo & Slayer trucks (except the E-Revo 2.0)
• Fits all modern T-Maxx and E-Maxx trucks running stock 5451X axles
• Will not work with 120-LT Long Travel rockers – Traxxas #5356
• Matching rear Revo True-Track Kit available
• Matching rear T/E-Maxx True-Track Kit available

• Axle Carriers:

  • Stock replacement – no modifications are needed to bolt them in.
  • Larger bearing bores accept RPM oversized bearings.
  • Included in each kit are two 15mm bearings and two 21mm bearings.
  • The wall thickness around the pillow-balls has been increased by 40% – eliminating split walls!
  • More than 20% more material supports the pillow-balls, preventing them from pulling through.
  • Redesigned reinforcing rib supporting the tie rod mount.
  • Redesigned boot lock tabs making removal of the silicone boots easier.
  • Press-fit bearings in the carrier means reduced movement of the axle in the carrier.

  Oversized Bearings:

  • Outer bearings are 6x15x5mm (stock is 6x12x4mm).
  • Inner bearings are 12x21x5mm (stock is 12x18x4mm).
  • Wider bearings create an additional 2mm of contact with the axle for smoother, longer running performance.
  • 3mm. larger bearings have balls a full 33% larger than stock!
  • The load ratings of RPM oversized bearings are double that of stock bearings and more than triple the fatigue rating of stock bearings as well!

  Pillow-Ball Setscrews:

  • Two-piece design uses aluminum and Delrin for the ultimate in holding power under extreme situations.
  • Our aluminum setscrews reduce movement of the pillow-balls in the carrier.
  • Our Delrin bushing caps have more than twice the contact area on the pillow-ball, keeping the pillow-balls locked in place at all times.

  What’s Included: RPM Revo axle carriers are sold with 1 left and 1 right axle carrier, 2 outer 15mm bearings, 2 inner 21mm bearings, 4 aluminum setscrews, 4 Delrin bushing caps, and detailed instructions to help install them on your truck. TWO packages will be needed to complete one vehicle (unless used with the RPM True-Track Rear End Conversion, then one package is all that is needed).

  Tech Notes: Due to increased material to support the pillow balls from pulling through the carrier, RPM Revo Axle Carriers will not work in conjunction with 120-LT Long Travel rockers (Traxxas #5356). RPM Axle Carriers will not work on the E-Revo 2.0.
• SPECIFICATIONS
• PARTS
• DOWNLOADS