Hobbywing QuicRun Fusion SE 1800kV w/ Integrated Esc 40Amp
U-matched hill-hold function
With 8 levels of drag brake force (Power) and 9 levels of Drag Brake Rate, drivers can fine-tune their vehicle’s hill-holding power and general driving. Overall, drag brakes can be 2 times stronger than normal brushless setups.
Designed for Durability
Silicon rubber gaskets, electronic buttons, and quality hardware ensure a long life for the Fusion SE. Made to take the abuse and conditions of daily RC bashers.
Ready for all weather and track conditions
IP-67 waterproof rating ensures the Fusion SE has protection from water, dust, and about anything else that gets thrown at it. Designed to withstand all conditions time and time again.
Note: The IP67 protection level mentioned above is splash-resistant, water-resistant and dust-resistant under normal use, and is tested under controlled laboratory conditions. Its effect is in the GB / T 4208-2017 (domestic) / IEC 60529 (overseas) standard to IP67 level. Splash, water and dust resistance are not permanently effective, and the level of protection may decline due to aging. Do not soak for a long time to avoid damaging the product.
Specifications:
- Type: 1/10 Brushless, Sensored, Waterproof (IP67) ESC & Motor Combo
- Cont./Peak Current: 40A
- Input Voltage: 2-3S Lipo/6-9 Cell NiMH
- BEC Output: 6V/7.4V @ 4A (6A peak)
- Motor KV: 1800KV
- Diameter/length of Motor: 36mm / 58.1mm
- Shaft diameter / exposed shaft length: 3.175mm / 16.5mm
- Motor Poles: 4
- Firmware Upgrade: Not Supported
- Size: 36X58.1mm
- Weight: 201g (including wires & connectors)
- Application: 1/10 Rock crawlers
Wires & Connectors:
- Input Wires: 14AWG-200mm
- Input Connectors: XT60
ESC Programing via:
- SET Button on ESC: Not Supported
- LED Program Box: Supported
- LCD Program Box: Not Supported
- OTA Programmer: Not Supported
- Program Port: Independent programming interface (switch position)
Frank Erik Hagen –
Funka som f^^😀, fin crawler motor.